ASG
IBM
Zystems
Cressida
Icon
Netflexity
 
  MQSeries.net
Search  Search       Tech Exchange      Education      Certifications      Library      Info Center      SupportPacs      LinkedIn  Search  Search                                                                   FAQ  FAQ   Usergroups  Usergroups
 
Register  ::  Log in Log in to check your private messages
 
RSS Feed - WebSphere MQ Support RSS Feed - Message Broker Support

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » Channel Triggering

Post new topic  Reply to topic
 Channel Triggering « View previous topic :: View next topic » 
Author Message
MQMB&WAS
PostPosted: Sat Sep 03, 2016 7:57 pm    Post subject: Channel Triggering Reply with quote

Centurion

Joined: 12 Jun 2016
Posts: 130

Hello guys,

I'm trying to setup channel triggering on my local system and I have a few questions. Appreciate any help.

so from what I understand,channel triggering is to start the sender channel when a message arrives in the xmitq instead of starting it manually at the time of mq restart. so, does the channel stay up after it is triggered? or does it go to inactive state after staying idle for sometime and needs to be triggered again when a new msg arrives?
Back to top
View user's profile Send private message
PaulClarke
PostPosted: Sat Sep 03, 2016 9:02 pm    Post subject: Reply with quote

Grand Master

Joined: 17 Nov 2005
Posts: 1002
Location: New Zealand

A sender channel definition has a Disconnect Interval (DISCINT). This is the number of seconds a channel can remain idle (ie. not sending messages) before it ends. You can set DISCINT to 0 which says don't ever end because of being idle but that is not recommended. If you set you channel to be triggered then setting a 'reasonable' DISCINT is advisable ie. not really big but not really small either. Personally I think the default of 6000 is a little long.

Cheers,

Paul.
_________________
Paul Clarke
MQGem Software
www.mqgem.com
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic  Reply to topic Page 1 of 1

MQSeries.net Forum Index » IBM MQ Installation/Configuration Support » Channel Triggering
Jump to:  



You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
Protected by Anti-Spam ACP
 
 


Theme by Dustin Baccetti
Powered by phpBB © 2001, 2002 phpBB Group

Copyright © MQSeries.net. All rights reserved.