| |
|
RSS Feed - WebSphere MQ Support
|
RSS Feed - Message Broker Support
|
  |
|
| Error Message BIP5153 |
« View previous topic :: View next topic » |
| Author |
Message
|
| hopfe_de |
 Posted: Fri May 24, 2002 3:57 am Post subject: Error Message BIP5153 |
 |
|
Acolyte
Joined: 03 Mar 2002
Posts: 58
Location: Frankfurt, Germany
|
Hi,
i know this is a very stupid problem. 
I try to make a smal programm to test my Message-flow, but every time i run my program the broker writes the error-message BIP5153.
The structure of the message and length are correct, but I'm not sure that all my properties are correct.
thanx,
Hopfe |
|
| Back to top |
|
 |
| Ward |
| Posted: Fri May 24, 2002 4:42 am Post subject: |
|
|
Voyager
Joined: 27 Jun 2001
Posts: 98
Location: Europe
|
Well you're not giving a lot of information here, but I think your problem can be solved by setting the properties right on your Input node.
I think you're using an MRM message in which case you should set:
Message domain: MRM
Message type: message name
Message Set: message set identifier
Message format: CWF
If all this doesn't help then give us some more info...
Cheers,
Ward.
_________________
IBM Certified Solution Designer -- WebSphere MQ V6.0
IBM Certified Solution Developer - WebSphere Message Broker V6.0
----------------------------
Visit Boat Dimensions |
|
| Back to top |
|
|
| kirani |
| Posted: Fri May 24, 2002 8:00 am Post subject: |
|
|
Jedi Knight
Joined: 05 Sep 2001
Posts: 3779
Location: Torrance, CA, USA
|
Also, don't forget to assign your message set to the Broker and perform deploy operation.
_________________
Kiran
IBM Cert. Solution Designer & System Administrator - WBIMB V5
IBM Cert. Solutions Expert - WMQI
IBM Cert. Specialist - WMQI, MQSeries
IBM Cert. Developer - MQSeries
|
|
| Back to top |
|
|
| hopfe_de |
| Posted: Sun May 26, 2002 9:48 pm Post subject: my failure |
|
|
Acolyte
Joined: 03 Mar 2002
Posts: 58
Location: Frankfurt, Germany
|
I check my parameter again, and find the error.
The problem was, that identifier and message-name were different. Now I changed the name in the Input-Node and it really works great.
Thanx for all your tipps. |
|
| Back to top |
|
|
| stiffann |
| Posted: Mon May 27, 2002 1:28 am Post subject: |
|
|
Apprentice
Joined: 17 Mar 2002
Posts: 26
|
Hi all,
I just want to insist on the fact that the behavior described in this error is due to a WMQI bug. Indeed, in theory, the values for Message Name and Message Identifier CAN be different.
The CSD02 corrects this bug.
Regards
Simon |
|
| Back to top |
|
|
|
|
|
| |
|
Page 1 of 1 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
